NICOS — Steel fabrication studio
- Pewel Ślemieńska
- 15 years
- Europe
Steel matched to architecture.
We design and fabricate custom fences, gates, balustrades and steel structures — from on-site measurement to installation.
How we work
From on-site measurement to installation
- 01
Measurement
We come to the plot and measure openings, slopes and levels. We check where to route the cabling and how to set the posts.
- 02
Design
We draw the element technically: profile, division of bays, fixing and finish. We show the decisions on the drawing before we cut any steel.
- 03
Fabrication
We cut and weld in the workshop to the drawing. We grind the welds and protect the surface with galvanizing and powder coating.
- 04
Installation
We set the posts, adjust the gate and the drive, and check the operation on site. We leave a finished element, not a list of corrections.
Project study / 02
Single-family home — front fence and gate
We designed the fence and gate together with the façade, so the profiles and spacing would echo the rhythm of the ground-floor windows. We set the entrance gate and the wicket in a single plane with the fence. We concealed the drive inside the post and routed the cabling under the driveway.
- Type
- Front fence and gate
- Scope
- Approx. 30 m of fencing, gate and wicket
- Material
- Closed steel profiles, posts 80×80 mm
- Finish
- Galvanizing and powder coating, anthracite
- Detail
- Profiles and spacing in the rhythm of the façade
Let's start with the specifics.
Tell us what you want to build and where. We'll get back to you with questions about the detail and scope, then arrange a date for an on-site measurement.